EMI Testing Services
Evaluation of Electro-Magnetic Interference from Electronic DevicesFCC PARTS 15 & 18 (USA)
ISED PARTS ES-001, ES-003, ES-005 (Canada)
EN 55011, EN 55013, EN 55014-1,
EN 55015, EN 55032, EN 300 386
EN 61000-6-3, EN 61000-6-4, (Europe)
AS/NZS CISPR 11, CISPR 13, CISPR 14.1, CISPR 15
AS/NZS CISPR 32 (Australia / New Zealand)
BSMI CNS 13438 (Taiwan)
KN 11, KN 14-1, KN 32, KN 61000-6-3,
KN 61000-6-4 (South Korea)
TS EMC (Singapore)
VCCI CISPR 32, J55013 (H22), J55014-1 (H20),
J55015 (H20), J55022 (H22) (Japan)
TCVN 7189:2009 (Vietnam)
3 / 10 METER OPEN AREA TEST SITE
A product’s radiated emissions from 9 kHz to 1 GHz are measured in an enclosed 10 meter open area test site (OATS) located in Southern NH.
Measurements may also be made on this test site at 3 Meters when measurement standards specify that measurement distance.
RF ANECHOIC CHAMBER
Radiated emissions pre-scans and emissions engineering tests are performed in an ambient free environment. The chamber can be used to measure products from 9 kHz to 40 GHz and beyond.
FREE SPACE MEASUREMENTS
ABOVE 1 GHz
Compliance Worldwide measures your product above 1 GHz in a free space environment as specified in ANSI C63.4 and CISPR 16-1-4 measurement standards.
A grid of anechoic absorber is placed between the antenna and the product to minimize standing waves (sVSWR) caused by reflections that would normally occur due to the ground plane.
The test site has been validated from 1 to 18 GHz per the measurement standards.
EN 61000-3-2, EN 61000-3-3,
JIS C 61000-3-2 Low Frequency Harmonics & Flicker Testing Services
Our Harmonics and Flicker Test Stand measures low frequency power line harmonics from 50 Hz to 2 kHz per the European requirements on single phase 230 Volt, 50 Hz powered products.
The flicker measurement consists of a 2 hour analysis on your products affect on 230 Volt, 50 Hz AC Mains that could potential cause light flicker due to switching high current loads within the product. This system is able to measure products up to 3 kVA.
Groundplane for Conducted Emissions
A 3 x 3.5 Meter Groundplane with a 2 x 2 Meter Vertical Plane used for Conducted Emissions. Filtered Power and LISNs with 120 VAC, 60 Hz at 20 Amps and 230 VAC, 50 Hz at 25 Amps. 208 VAC, 60 Hz Delta 3 Phase is also available up to 30 Amps.